![]() ![]() For more information, read 's Financial Services and Credit Guide (FSCG) The information provided constitutes information which is general in nature and has not taken into account any of your personal objectives, financial situation, or needs. Rates and product information should be confirmed with the relevant credit provider. If you decide to apply for a credit product listed on, you will deal directly with a credit provider, and not with. is a general information provider and in giving you general product information, is not making any suggestion or recommendation about any particular product and all market products may not be considered. Pty Ltd ACN 161 358 363 operates as an Australian Financial Services Licensee and an Australian Credit Licensee Number 515843. Read about how Savings Media Group manages potential conflicts of interest, along with how we get paid. In the interests of full disclosure, the Savings Media Group are associated with the Firstmac Group. ,, , and Performance Drive are part of the Savings Media group. To be considered, the product and rate must be clearly published on the product provider's web site. Some providers' products may not be available in all states. Rather, a cut-down portion of the market has been considered. The entire market was not considered in selecting the above products. AFSL and Australian Credit License Number 515843.So it is important if you are buying DA approved sites, to have your own surveyor double check the plans and proposed levels which are based on the original contour survey. As the site sloped from rear to front, the retaining required on this rear boundary was much more than the builder had allowed for based on the plans. This was not picked up until after site preparations started and the site was cut. On one site we found the surveyor (not mine, as this was a DA approved site purchased) had taken a measurement from one meter in from the rear boundary instead of right on the rear boundary. These costs need to be allowed for by the builder and he depends on the measurements on the contour survey for this data.Īccuracy of a survey is extremely important. For example, a sloping site will need to be levelled if you are using a slab construction and therefore the approximate height of retaining walls and volume of spoil to be removed need to be calculated. Once the architect or draftsperson has a contour survey then they can begin work on the plans and the survey will indicate how much site works may be required. All contour lines must close either within the map boundary or outside.Closed contour lines with reducing levels towards the centre indicate pond or other depression.Closed contour lines with higher elevation towards the centre indicate hills.Equally spaced contour lines indicate uniform slope.Widely spaced contour lines indicate gentle slope.Closely spaced contour lines indicate steep slope.No two contour lines can meet or cross each other except in the rare case of an overhanging vertical cliff or wall. ![]()
0 Comments
Leave a Reply. |